During the development of the RDDRONE-FMUK66 (NXPhlite) several hardware issues were discovered and fixed in newer revisions. Boards send to HoverGames participants should NOT have these issues.
Bi-directional buffer U50 was found to oscillate when UART4 is set to higher baudrates, or when long cables are connected to the TELEM1 connector. As a solution, the U50 levelshifter was removed from the board and a 220R resistor pack was placed in parallel.
The GND pin of the PWM1 connector on the PWM servorail was left floating. This might cause distortion of the PWM signal that goes to the ESC. As a quick solution, the PWM1 GND can be soldered to the PWM2 GND (which is correctly connected to the ground plane).
The team has discovered that the auto-sensing bi-directional buffer part U50 is configured for 5V signalling. This is causing the lines to oscillate when connected to the 3V3 signalling on the typical SiK telemetry radios used. The solution is to either remove U50, or connect the "B" side of the buffer to 3V instead of 5V. This is precision work and very difficult to do by hand. It will be corrected in the next revision. If you are unable to get this done yourself, please contact Iain Galloway or Matthias Wilkens to arrange a reworked replacement board.
The first prototype version V01 / Rev. A of the DCD-LZ-ADAPT needs small rework in order to allow the J-Link debugger and the FTDI cable to work simultaneously.
The FTDI cable supplies 5V on VCC, and this causes the J-Link debugger to think the board is in reset.
VCC from the processor needs to appear on pin 1 of the SWD header.
The first build of boards had the oscillator Y1 installed upside down. The markings on this part are a little challenging based on the datasheet and the actual visibility on the part. The images below should help clarify how it is to be installed.
