Serial port meant for use with telemetry radios, or to communicate with a companion computer.
The serial port can be used to communicate with the FMU either remotely or with a companion computer on the drone itself. Often telemetry radios are connected to this port to provide a wireless connection with a ground control station. By default, PX4 listens and communicates using the MAVLink protocol on this port.
Serial 1 / Telemetry 1 / (UART 4) connector pinout
Pin
The labeling of RX and TX is inconsistent on some radios. Typically RX on the FMU connects to the TX from the radio. Check your cable and radio! Often the cable that comes with the radio set is wired correctly, even if the labeling is wrong.
RDDRONE-FMUK66 Rev. C schematic
RDDRONE-FMUK66 Rev. B schematic
Rev. B (and older boards) are not supported anymore. This information is left for reference.
Telemetry
Telemetry radio sets usually have different versions. The 433 MHz version is used in Europe, while 915 MHz is used in the USA. Make sure you have the right version for your location.
