🤖
NXP Mobile Robotics
  • NXP Mobile Robotics
  • Hardware
    • FMUK66 Vehicle Controller
      • Connectors
    • FMURT6 Board
      • DEMO: Pixhawk-4 GPS Module with Zephyr
    • NavQ+ Companion Computer
      • Connectors
    • BMS772 Smart Battery
      • Connectors
    • UCANS32K1 CAN Node
      • Connectors
    • MR-CANHUBK3
      • Connectors
    • T1ADAPT Ethernet Adapter
      • Connectors
    • T1ETH8 Ethernet Switch
      • Connectors
  • 🤖ROS2 Robotics Software
    • Ubuntu configuration for ROS2
  • ROS2 specific enablement
    • Remote control setup on ROS2
  • Software
    • Flashing
      • Linux - flashing
      • Windows - flashing
    • PX4 Autopilot
    • Apache NuttX
    • Zephyr
    • Ubuntu + ROS2
  • Development Tools
    • WSL
    • MCUXpresso
      • Kinetis K66 SDK
    • Visual Studio Code
    • QGroundControl
    • Pixy2
  • Extra Content
    • Downloads & Links
    • FAQ
    • Contacts
Powered by GitBook
On this page

Was this helpful?

  1. Hardware
  2. T1ETH8 Ethernet Switch

Connectors

The different connections available on the board and where they are located

Below is a descriptive photo of the connections on the T1ETH8 board:

PreviousT1ETH8 Ethernet SwitchNextUbuntu configuration for ROS2

Last updated 2 years ago

Was this helpful?