The MR B3RB car should look like this in the pre-production unit after opening the box.
UPDATING: The production units will instead include the larger side plastic skirts. The small plastic clips shown below will not be used. It will no longer be required to replace the top plate screws and clips.
Use a hex screwdriver or Allen Key and remove all top and side screws securing the top plate to the metal frame and carefully set them aside. These screws are important for later steps when you'll need to reattach the metal frame.
After removing the screws, carefully detach the eight plastic holders from the side. Remember to keep the screws and nuts in a safe place, as they will be needed later.
The MR B3RB car should look like this in the pre-production unit after opening the box.
Proceed with attaching the side parts of the car.
Re-use the screws and locknuts that held the top plate to the side metal, that you took out previously
UPDATING: The production units will include the larger side plastic skirts instead of the small plastic clips shown below. It will no longer be required to remove the top plate screws and clips.
Once attached, the side components should look like this. To better illustrate the process, one side is shown attached while the other remains detached.
The MR B3RB car should look like this in the pre-production unit after opening the box.
Proceed to install the LED lights. Follow the image sequence for assembling the front part of the car pieces:
Do NOT overtighten the screws and nuts holding the LED light assembly together. Just snug them up to the point that the lens and bumper assembly doesn't move easily.
UPDATING: Production units will not include the notch in the clear lenses
This is a pre-production prototype. We have found that it is better to install the lenses so the notch cutout does NOT clear the connector and instead sits on TOP of the connectors. This helps prevent over tightening.
The clear lenses generally have brown protective paper film that must be removed before use.
Find the 13mm long screws in the kit of black screws included in the kit. Reuse the lock nuts that were originally installed.
See this link for clarification on the correct screws to use: https://app.gitbook.com/o/-L9GLsni4p7csCR7QCJ8/s/U93yDWZcgjXGgsC1Duqv/~/changes/153/whats-in-the-box/witb-mr-b3rb-bmf#fastener-screw-m3-x-0.5-x-5.0mm-hex-drive-button-head-s.no.-16-fastener-screw-m3-x-0.5-x-10mm-hex-dr
Note: the polycarbonate lens has a cutout, due to assembly changes, it no longer matters if this is facing upward or downward.
The front part of the car should appear as follows:
Repeat the same assembly process for the rear of the car. Note that the back piece is identical to the front one but slightly longer.