Introduction

The AUX port contain is by default configured for I2C6 + GPIO. Alternative pinmuxing is available on AUX for UART4. Any alternative configurations are not default and need to be configured in the Linux Image and .dtb files

AUX interface voltage

The signaling from the SOM to the NavQPlus carrier board on J12 is at 3V3

Any alternative pinmuxed output configurations on the AUX connector would also be 3V3 signaling.

Aux Locator

Schematic

UART

Note that J11/UART4 is the default location for UART4 signals. Also by default UART4 is assigned to the M7 Core on the i.MX8M Plus. An RTOS such as FreeRTOS or Zephyr would normally use it as the default console to the embedded MCU.

GPIO

J12 "AUX" is includes two pins for GPIO labelled GPT1_CAPTURE1 and GPT2_CAPTURE2

ESD Protection

All the UART signals are protected from ESD using the Nexperia IP4292CZ components. This is part of an optimized BOM as they are also required for the USB interfaces. In additional to its exceptional performance the board layout may be optimized because of being able to route traces straight under the component.

Software

<TODO- describe how to access these GPT pins in software>

DRAFT DRAFT DRAFT

Rest and PMIC Control "GPIO"

A series of test points are available to access the Reset and PMIC controls one the NavQPlus board. These could be used where a remote button or other external controls are desired.

Misc GPIO Locator

<TODO> - complete mapping from Schematic to board layout (image here)

There are several ports which may have or may be configured for GPIO connection. In addition there are several SMT pads designed to allow access to GPIO and signals such as the PMIC controls. Refer to the schematics for details.

<<TODO - add more detail here, and pictures of the schematics. Add an example pin access if available>>

UART4 interface voltage

The signaling from the SOM to the NavQPlus carrier board on J11 is at 3V3

Alternative output is on the AUX connector at location J12 also at 3V3 signalling. However this is not the default linux BSP, and would require changes to the dtb files.

Schematic

Note that J11/UART4 is the default location for UART4 signals. Also by default UART4 is assigned to the M7 Core on the i.MX8M Plus. An RTOS such as FreeRTOS or Zephyr would normally use it as the default console to the embedded MCU. You may note that the signal names are differed on J11 vs J12. This is only a labelling detail, since the pinmuxing on the chip is used to "move" the UART4 interface from one set of pins on the MPU (and board to board header). In order to route these signals independently on the carrier board, they need their own net names.

All the UART signals are protected from ESD using the Nexperia IP4292CZ components. This is part of an optimized BOM as they are also required for the USB interfaces. In additional to its exceptional performance the board layout may be optimized because of being able to route traces straight under the component.