🔋
RDDRONE-BMS772
bms3.4-9.1
bms6.0-11.0bms5.0-10.1bms4.0-10.1bms3.6-10.0bms3.4-9.1
bms3.4-9.1
bms6.0-11.0bms5.0-10.1bms4.0-10.1bms3.6-10.0bms3.4-9.1
  • Introduction
  • Disclaimer - CAUTION WARNING
  • Check for updated code immediately
  • Known areas for change or alignment
  • Board User Guide
    • Getting to know the hardware
      • Board overview
      • Board features
      • Board block diagram
      • Board organization
      • Board components
    • Characteristics of the RDDRONE-BMS772 board
    • Getting started with the RDDRONE-BMS772
      • Kit content
      • Required equipment and software
      • Configuring the hardware
      • Start-up checklist
      • Flashing firmware to the RDDRONE-BMS772
      • Accessories and tools for development
      • Using the command line interface (CLI)
      • Get the UAVCAN messages with the UCAN board
  • Software guide - NuttX
    • Introduction
    • Software block diagram
    • BMS application state machine
    • Realization
    • First start-up
    • Command Line Interface (CLI)
    • How to enable the battery temperature sensor
    • Charging with the BMS
    • Parameters of the BMS
  • Software guide - bare metal and other
    • Battery Cell Controller (BCC) drivers
  • Software guide - PX4
    • Introduction
Powered by GitBook
On this page

Was this helpful?

Export as PDF
  1. Board User Guide

Getting to know the hardware

PreviousKnown areas for change or alignmentNextBoard overview

Last updated 2 years ago

Board overview
Board features
Board block diagram
Board organization
Board components