🔋
RDDRONE-BMS772
bms5.0-10.1
bms6.0-11.0bms5.0-10.1bms4.0-10.1bms3.6-10.0bms3.4-9.1
bms5.0-10.1
bms6.0-11.0bms5.0-10.1bms4.0-10.1bms3.6-10.0bms3.4-9.1
  • Introduction
  • Disclaimer - CAUTION WARNING
  • Check for updated code immediately
  • Known areas for change or alignment
  • Board User Guide
    • Getting to know the hardware
      • Board overview
      • Board features
      • Board block diagram
      • Board organization
      • Board components
    • Characteristics of the RDDRONE-BMS772 board
    • Getting started with the RDDRONE-BMS772
      • Kit content
      • Required equipment and software
      • Configuring the hardware
        • Cell Terminal Connections
      • Start-up checklist
      • Flashing firmware to the RDDRONE-BMS772
      • Accessories and tools for development
      • Using the command line interface (CLI)
      • Get the UAVCAN messages with the UCAN board
  • Software guide - NuttX
    • Introduction
    • Software block diagram
    • BMS application state machine
    • Task priorities
    • Realization
    • First start-up
    • Command Line Interface (CLI)
    • Display
    • UAVCAN
    • How to enable the battery temperature sensor
    • Charging with the BMS
    • Parameters of the BMS
  • Software guide - bare metal and other
    • Battery Cell Controller (BCC) drivers
  • Software guide - PX4
    • Introduction
Powered by GitBook
On this page

Was this helpful?

Export as PDF
  1. Board User Guide

Getting started with the RDDRONE-BMS772

PreviousCharacteristics of the RDDRONE-BMS772 boardNextKit content

Last updated 2 years ago

Kit content
Required equipment and software
Configuring the hardware
Start-up checklist
Flashing firmware to the RDDRONE-BMS772
Accessories and tools for development
Using the command line interface (CLI)
Get the UAVCAN messages with the UCAN board