🔋
RDDRONE-BMS772
bms4.0-10.1
bms4.0-10.1
  • Introduction
  • Disclaimer - CAUTION WARNING
  • Check for updated code immediately
  • Known areas for change or alignment
  • Board User Guide
    • Getting to know the hardware
      • Board overview
      • Board features
      • Board block diagram
      • Board organization
      • Board components
    • Characteristics of the RDDRONE-BMS772 board
    • Getting started with the RDDRONE-BMS772
      • Kit content
      • Required equipment and software
      • Configuring the hardware
      • Start-up checklist
      • Flashing firmware to the RDDRONE-BMS772
      • Accessories and tools for development
      • Using the command line interface (CLI)
      • Get the UAVCAN messages with the UCAN board
  • Software guide - NuttX
    • Introduction
    • Software block diagram
    • BMS application state machine
    • Task priorities
    • Realization
    • First start-up
    • Command Line Interface (CLI)
    • UAVCAN
    • How to enable the battery temperature sensor
    • Charging with the BMS
    • Parameters of the BMS
  • Software guide - bare metal and other
    • Battery Cell Controller (BCC) drivers
  • Software guide - PX4
    • Introduction
Powered by GitBook
On this page

Was this helpful?

Export as PDF

Check for updated code immediately

The RDDRONE-BMS772 may have test software or no software installed from the factory.

Review this manual to understand what is the latest software and how to update it. There may be more than one option:

  • PX4/NuttX target

  • NuttX target

  • S32K design studio project

PreviousDisclaimer - CAUTION WARNINGNextKnown areas for change or alignment

Last updated 5 years ago

Was this helpful?