🔋
RDDRONE-BMS772
bms6.0-11.0
bms6.0-11.0
  • Introduction
  • Disclaimer - CAUTION WARNING
  • Check for updated code immediately
  • Known areas for change or alignment
  • Board User Guide
    • Getting to know the hardware
      • Board overview
      • Board features
      • Board block diagram
      • Board organization
      • Board components
    • Characteristics of the RDDRONE-BMS772 board
    • Getting started with the RDDRONE-BMS772
      • Kit content
      • Required equipment and software
      • Configuring the hardware
        • Cell Terminal Connections
      • Start-up checklist
      • Flashing firmware to the RDDRONE-BMS772
      • Accessories and tools for development
      • Using the command line interface (CLI)
      • Get the CyphalCAN messages with the UCAN board
      • How to use the SW emergency button / kill switch / cut off
      • DroneCAN
  • Software guide - NuttX
    • Introduction
    • Software block diagram
    • BMS application state machine
    • Task priorities
    • Realization
    • First time software configuration of the BMS
    • First start-up messages
    • Command Line Interface (CLI)
    • Display
    • CyphalCAN
    • How to enable the battery temperature sensor
    • Charging with the BMS
    • Parameters of the BMS
    • How to use SMBus (I2C peripheral)
    • How to use NFC
    • How to get access to the BCC (BMS IC) safety library.
  • Software guide - bare metal and other
    • Battery Cell Controller (BCC) drivers
    • Model-Based Design Toolbox MBDT MATLAB Simulink coding
  • Software guide - PX4
    • Introduction
Powered by GitBook
On this page

Was this helpful?

Export as PDF
  1. Board User Guide

Getting to know the hardware

Board overviewBoard featuresBoard block diagramBoard organizationBoard components
PreviousKnown areas for change or alignmentNextBoard overview

Was this helpful?