Step 2b: Mounting MR-CANHUBK344
Last updated
Last updated
MR-CANHUBK344 is the real time controller board for the robot. After successfully attaching the NavQPlus, the next step is to install the MR-CANHUBK344 evaluation board.
The MR-CANHUBK344 board should be attached in the highlighted holes of the following image. Reuse the M3x5mm screws that were previously removed from the side skirts. M3x5mm screws should be used to screw in from the bottom side.
Be cautious to not squeeze the wires attached to the NavQPlus!
Upon completion, the entire assembly should appear as follows: