Wiring Power cables

Introduction

There are two 5 pin JST-GH cables that provide battery power to the MR-CANHUBK344 and the NavQPlus. They are 5 pins, with no wire in the center position. Two wires are battery voltage+ and two wires are battery voltage-. Be sure to limit the voltage applied at the battery to <20V or the specified ratings for any boards plugged in. The nominal battery voltage is expected to be ~12V,

NavQPlus and MR-CANHUBK344 will be soon updated to ship with longer power cables.

Power cable from PDB to MR-CANHUBK344

  • Connect is the EXTRA LONG power cable from the MR-CANHUBK344 to the Power Distribution Board.

  • The normal length power cable can be similarly connected to the NavQPlus

  • ZIP TIE the cables to the edge of the top plate and make them neat.

Extra long power cable for MR-CANHUB to PDB connection.

These cable connect to the 5 pin JST GH on the PDB. Either connector is ok. They are both the same.

And the other end must be connected to this pin on the MR-CANHUBK344

The following picture depicts the connections in an animated way.

Last updated

Was this helpful?