Wiring Power cables

Introduction

There are two 5 pin JST-GH cables that provide battery power to the MR-CANHUBK344 and the NavQPlus. They are 5 pins, with no wire in the center position. Two wires are battery voltage+ and two wires are battery voltage-. Be sure to limit the voltage applied at the battery to <20V or the specified ratings for any boards plugged in.

The nominal battery voltage is expected to be ~12V,

Long and short power cable

  • There is one long and one short power cable included in the kit.

  • Connect is the LONG power cable from the MR-CANHUBK344 to one of the the Power Distribution Board Pout connectors.

  • The shorter length power cable can be similarly connected to the NavQPlus

  • When done, ZIP TIE the cables to the edge of the top plate and make them neat.

PreviousSteering Servo connectionNextWiring Power to MR-CANHUBK344

Last updated

Was this helpful?