WITB Cables and Screws

Because this is the pre-production version of the MR-B3RB, some cables and screws are not as clearly separated in the sub-kits as they could be. For clarity we will mention them and their purpose here.

Cables and Screws Components

The wires represented by rows with serial numbers 6 and 7 in the following table are not included in the current (Pre-Production) unit. Refer Errata on Pre-Production unit. In their place, incompatible cables are included and their pictures are shown in the diagrams on this page, for reference purposes.

S.No.	Description	Quantity
1	Cable, Lidar to NavQPlus 6-Pin JST-GH to 4-Pin JST-PH	1
2	Cable, XT60 PANEL MOUNT ADAPTER to XT60 Connector with Cover	1
3	XT60 Connector with Cover	1
4	Cable, Twisted, Black, 5-PIN JST-GH to 5-PIN JST-GH (With only 4 wires connected and middle wire unconnected)	1
5	Cable, 3 Pin Female Dupont Jumper to 6-PIN JST-GH	1
6	Cable, Back APA102 Strip (IN Port) to CANHUBK3, 7-PIN JST-GH to Stemma QT/Qwiic JST SH 4-Pin	1
7	Cable, Back APA102 Strip (OUT Port) to Front APA102 Strip (IN Port), Stemma QT/Qwiic JST SH 4-Pin to Stemma QT/Qwiic JST SH 4-Pin	1

Cables and Screws Diagrams

Cables and Connectors