NXP MR-B3RB (Buggy3 RevB)

Introduction
MR-B3RB History
Block Diagram
MR-B3RB-M Mechanical Assembly Guide
MR-B3RB-BMF manufacturer Assembly Guide
MR-B3RB-S Mechanical Assembly Guide
Recommended Battery specification
- Battery monitor usage
Manufacturing Addendum
- Checklist for shipping pre-assembled training units
- MR-B3RB-BMF Base Mechanical Frame Assembly Guide
Software
CANHUB-ADAP
- CANHUB-ADAP (RevC) Schematics
B3RB-Tutorials
USER contributed
- High Gain WiFi Antennas
- 3D Printed parts
  - Power switch
  - Rotating Battery Plug Mount
Untested and rough notes
Archive

Powered by GitBook

On this page

Was this helpful?

Battery monitor usage

PreviousRecommended Battery specification NextManufacturing Addendum

Last updated 1 month ago

MR-B3RB units have a power monitor built into the PDB board. This will tell you the total pack voltage and individual cell voltage. It will alarm when the cell voltage goes too low.

Press the button on top to set the ALARM voltage to 3.2volts The Battery monitor is connected as shown below