MR-B3RB-BMF Base Mechanical Frame Assembly Guide
B3RB- Base Mechanical Frame Assembly. Mounting the base frame on the car.
Last updated
B3RB- Base Mechanical Frame Assembly. Mounting the base frame on the car.
Last updated
Normally the MR-B3RB-BMF (Base Mechanical Frame) will be pre-assembled. Therefore, these instructions will NOT be needed and are included only for completeness.
Note the MR-B3RB-BMF (Base Mechanical Frame) uses plastic clips and screws to hold the top circuit board plate in place. When preparing the kit MR-B3RB-M, these side clips will be discarded and replaced with larger plastic side plates. The side plates are part of the MR-B3RB-MUK (Mechanical Upgrade Kit) components including plastic front, rear, side and metal top and side covers.
Link: https://a360.co/3T5l4Yi
Link: https://a360.co/47FQWXS
Gather the buggy aluminum cage, the PDB board and the PDB mount.
Mount the PDB to the cage using the plastic mount and 8 M3x5 screws. Make sure you install the board with the right orientation, as the XT60 connector needs to be on the front of the car.
Mount the subassembly to the car frame using 4 M3 F-F standoffs and 8 M3x5 socket head cap screws.
Install the 8 nut housings to the frame using an M3 locknut and a M3x8 screw per housing.
Install the 2 LED boards using two M3x8 screws and two M3 locknuts per board.
Install the top frame using 8 M3x5 screws.