🌉
NXP MR-CANHUBK344: CAN-FD to T1 ETH.
  • MR-CANHUBK344
  • MR-CANHUBK344 Block Diagram
  • Disclaimer
  • Kit Contents
  • Getting Started
    • Connecting a debugger
    • Programming using J-Link Commander
    • Programming with Opensource tools
      • MCU-Link-MR
      • PyOCD and MCU-Link
      • Programming with Zephyr West
      • BlackMagic debug
  • I/O Quick Reference
  • Hardware Reference
    • S32K344 MCU
    • FS26 PMIC
      • PMIC and Board Power Up Sequence
    • Connectors & User I/O
      • Power Input
      • CAN Buses
      • 100Base-T1 Ethernet
      • UARTs
      • I2C Buses
      • SPI
      • Pixhawk IMU
      • Programming Interface
      • User Buttons
      • NFC Antenna
      • PWM & GPIO Headers
      • Analog Potentiometer
    • Board Status LEDs
    • Design Files
      • 3D Printable parts
  • Available Software
    • IEEE 1722 CAN-over-Ethernet Example Application
    • Apache NuttX (RTOS)
    • PX4 Autopilot
      • MR-CANHUBK3-ADAP
    • Zephyr (RTOS) Resources
      • Cognipilot
      • Demo: APA102 RGB LED
Powered by GitBook
On this page
  1. Hardware Reference
  2. Design Files

3D Printable parts

Enclosures and adapters avaiable for the MR-CANHUBK344

PreviousDesign FilesNextIEEE 1722 CAN-over-Ethernet Example Application

Last updated 1 year ago

CtrlK

Enclosures and adapters available for the MR-CANHUBK344. Including user-submitted content.

Some models have top and bottom pieces shown together in one single CAD file. In order to download individual .STL files for 3D printing you may need to click the Model Browser button (shown in blue below) and change the visibility so only one part is showing before downloading. Model browser icon in blue

Click the eyeball icon to turn visibility on or off for each section of the design

Enclosure for MR-CANHUBK344.

Note: The CANHUB-ADAP plugs on top and is NOT enclosed.

Direct URL link: https://a360.co/45mNxMu