Wiring RGB LED (PDB V0)
Last updated
Last updated
Wiring instructions will be demonstrated using images and GIFs for clearer visualization of the process.
The RGB LEDS communicate using a modified SPI type that is unidirectional. The power for the LEDs is supplied by the PDB, and the SCL SDA lines attach to a SPI port on the MR-CANHUBK344
You need to have mounted first the LED lights and covers. This step has been explained in this section:
First, we'll show hot to connect the LEDs cables from the LEDs panels to the PDB and the MR-CANHUBK344.
Use the 4-pin cable with a protective covering to connect from the front to the rear LED assembly ends.
Connect the rear LED to the PDB (Power Distribution Board) and the MR-CANHUBK344.
The following image shows the LED lights setup with the left side representing the rear and the right side indicating the front of the car.
The following images show a zoomed vision of the wiring:
The remaining pin is this one:
That must be connected on the following pin of the MR-CANHUBK344:
If you have correctly followed these steps the wiring setup of the LEDs cables should be finished.