Wiring Power cables

Introduction

There are two 5 pin JST-GH cables that provide battery power to the MR-CANHUBK344 and the NavQPlus. They are 5 pins, with no wire in the center position. Two wires are battery voltage+ and two wires are battery voltage-. Be sure to limit the voltage applied at the battery to <20V or the specified ratings for any boards plugged in. The nominal battery voltage is expected to be ~12V,

NavQPlus and MR-CANHUBK344 will be soon updated to ship with longer power cables.

Power cable from PDB to MR-CANHUBK344

• Connect is the EXTRA LONG power cable from the MR-CANHUBK344 to the Power Distribution Board.

• The normal length power cable can be similarly connected to the NavQPlus

• ZIP TIE the cables to the edge of the top plate and make them neat.

Extra long power cable for MR-CANHUB to PDB connection.

These cable connect to the 5 pin JST GH on the PDB. Either connector is ok. They are both the same.

And the other end must be connected to this pin on the MR-CANHUBK344

The following picture depicts the connections in an animated way.

M10 GPS connection

You need to add first the M10 GPS mount to the metal frame. This is explained in this section: #install-m10-gps-module

This is the M10 GPS

M10 GPS

Pin on MR-CANHUBK344 for GPS

And this is all the cable connections available for now.