Step 2e: Attach camera to front plastic mount

Attach the NavQPlus camera to the front plastic mount.

The camera housing included with the NavQPlus mounts to the front "GoPro" style mount on the front plastic:

You must reuse the screw and bolt that was part of the original camera mount. (This is from the white plastic mount included with the NavQPlus) Follow earlier instructions to remove the mount from around the cable if necessary.

The camera flex cable should come out the back of the NavQPlus and loop over top of it. Then route under the lower edge of the front bracket. and up into the camera module. The final setup should look like this:

Camera Flex cable routing over top of NavQPlus and under front bracket.

Camera Flex cable routing to camera module. Coming up from bottom.