Top lidar brace

This is for the MR-B3RB pre-production version

These instructions were written for the pre-production vesion of MR-B3RB where the lidar is in the middle. For production version It is likely that the position of the lidar will change slightly and move closer toward the front.

  • There are only three screws that hold the LIDAR in place. The side without screws has the wiring conneection. On the metalwork there will be an oval cutout on that side.

  • Use 3x M2.5 screws and nuts to attach the Lidar to the top lidar brace as shown below.

  • Remember to remove the plastic protective film from the lidar

  • Note the small arrow on top of the LIDAR unit. It needs to face the forward direction which is the short flat side of the Top Lidar Brace. (You may need to flip the metal over to match the orientation shown.)

Support post on top plate

  • An extra 35mm purple standoff and screws is provided in the kit. Screw this into one of the extra middle holes in order to provide upward pressure to the lidar brace / arch.

  • Use the extra screw in the top of the post to unwind until it touches the brace to provide support.

Use 3 M2.5mm screws and nuts to attach as shown, Be sure to remove the plastic film
Ensure the forward arrow is facing the short flat side of the top brace

Last updated

Was this helpful?