Step 1d: Adding XT60 extension Mount

The replacement rotating battery extension mount.

(OLD Battery cable panel mount bracket instructions.)

This step needs this 3D printed part:

And this cable:

Please make sure you can find them. It will also need two screws of 1cm and M2.5 size. You can find them on this boxM2/M2.5/M3 SCREW FASTENER KIT FOR WLTOYS 144001 1/14 RC (S.No. 25)

Attach the two screws in this position:

Now you need to take out the bottom metal frame where the PDB (Power Distribution Board) is attached, make sure to detach the cables connected to the PDB. To take out the metal frame, quit the highlighted screws in the following image:

Now use two M3*6mm screws and two M3 nuts from this box:

And securely attach the XT60 panel mount and the cable adapter in this position:

Last updated

Was this helpful?