MR-B3RB-BMF Base Mechanical Frame Assembly Guide

B3RB- Base Mechanical Frame Assembly. Mounting the base frame on the car.

Introduction

Base Mechanical Frame assembly

Normally the MR-B3RB-BMF (Base Mechanical Frame) will be pre-assembled. Therefore, these instructions will NOT be needed and are included only for completeness.

MR-B3RB-BMF (Pre-Production) assembly Video

Link: https://a360.co/3T5l4Yi

Bill of materials

Link: https://a360.co/47FQWXS

Procedure

  1. Gather the buggy aluminum cage, the PDB board and the PDB mount.

  2. Mount the PDB to the cage using the plastic mount and 8 M3x5 screws. Make sure you install the board with the right orientation, as the XT60 connector needs to be on the front of the car.

  3. Mount the subassembly to the car frame using 4 M3 F-F standoffs and 8 M3x5 socket head cap screws.

  4. Install the 8 nut housings to the frame using an M3 locknut and a M3x8 screw per housing.

  5. Install the 2 LED boards using two M3x8 screws and two M3 locknuts per board.

  6. Install the top frame using 8 M3x5 screws.

Last updated

Was this helpful?