Checklist for shipping pre-assembled training units

This checklist is primarly for units prepared to be assembled and shipped for trainings

This checklist is prepared for training units that will be shipped elsewhere This is a checklist for use if you have already assembled a unit and need to ship it to another location. It is to ensure the recipient has all the components needed, and the kit will be functional.

Short checklist for shipping

Changes before shipment

Critical support components that must be in box


Photos and videos of the checklist items

Checklist items before shipping

ENSURE QDEC and RGB LED cable in place, other cables zip tied down and neat.
ENSURE: DEBUG-CONSOLE cable on MR-CANHUBK344 attached and tucked in along side
ENSURE: CONSOLE cable on MR-NavQPlus attached and tucked in along side
Ensure rotating battery connector holder is free rotating

APPLY Small Cognipilot sticker. Rear corner near MR-CANHUBK344 debug cable
APPLY: Emcraft sticker. Middle flat plate between boards

Changes to make before shipment

GPS module and mast disconnected and packaged up
GPS module placed under front or rear for shipment

Ready for shipment: Lidar and mount inverted. NXP logo applied to motor side cover, Medium Cognipilot logo applied.


Ensure these critical items are included

Put them in a single bag.

ENSURE in Pack: DCD-LZ (DEBUG+ Console board), FTDI USB-UART Cable, Segger Jlink
Ensure in Pack: Console Cable for NavQPlus

Esure in pack: low battery monitor
EnsCognipilot Neuralprobe debug/console board
Esnure in Pack: IX Industrial to RJ45 cable
ADD: (Temporary) (1) unsoldered XT60 make connector


REMOVE the following components if present

REMOVE: USB-C to USB-A cable (use only USB-C to USB-C)
REMOVE: Original RGB LED lighting cables (2)

Last updated

Was this helpful?