Step 2c: Mounting LIDAR and Standoff for LIDAR arch stability

Three M2.5 Cap Screws and Nylock nuts are included with the LIDAR
Use the included RC-CAR wrench to hold the nuts
Double check that the lidar is facing the front as shown here.

Standoff for LIDAR arch stability

There is a orange or black 3d printed plastic standoff post which also acts to protect the cable. The file will also be provided in 3D Printed parts page See image below

ZIptie the lidar cable and standoff as shown in this picture. The wire should wrap around the back of the standoff.
The wires should wrap around to the back of the standoff and ziptie here as well.

Do NOT attach the top plate to the B3RB, yet. This can only be done after completation of step 3: wiring.

Updated 3D printed LIDAR stand

Last updated

Was this helpful?