> For the complete documentation index, see [llms.txt](https://nxp.gitbook.io/nxp-cup/llms.txt). Markdown versions of documentation pages are available by appending `.md` to page URLs; this page is available as [Markdown](https://nxp.gitbook.io/nxp-cup/2019-dfrobot-chassis-developer-guide/landzo-car-model/known-issues/camera-module/deprecated-lzcamadapt-camera-adapter.md).

# \[Deprecated] LZCAMADAPT Camera adapter

\* **NOTE THIS BOARD IS NOT CORRECT** \*

 **Do not use. I was rushing and made a dumb mistake. See LZCAMADAPT2 for the correct version. The Correct board will have the silkscreen printed "LZCAMADAPT2"**

* [ ] NOTE: This is untested, but i think this version of the adapter board would allow the old \*original\* (pre-alamak) camera to work with this board.

A simple camera adapter board has been prepared to jumper from the original 5 pin 0.100" header/socket to the smaller 2x4 0.50" header/socket. Only "Version 2" camera module needs this adapter since the ribbon cable on "Version 2" already has the correct 0.50" connector, it just needs to be removed from **its own** adapter board that converts to 5 pin.

* The board and schematic are available in EAGLE CAD format.

## PCB

The small adapter looks like this:

![](/files/-L9GM4ww5Ws-g_1qcTvr)

* [x] (Image updated 2018.1.29 to show silkcreen as fabricated)

## Schematic

Thee schematic is very basic. Just connects the pins as follows:

![](/files/-L9GM4xDKy_YtoV1aOMo)

![](/files/-L9GM39QvrV3us70mdQi)

**Image 1:** The image above shows the socket (connector) installed on the camera pin header. Normally this would be soldered onto the PCB. This image was taken just as a check that it fit well.

![](/files/-L9GM4xZlW7oIhzAmmE6)

**Image 2:** The image above shows a paper version of the CAMADAPT PCB and how the 5 pin connector would solder in place. The socket (connector) shown in **Image 1** should solder on the opposite side of this PCB

## Board Modification

If you really want to you can cut and jumper the traces to make it like CAMADAPT2. Below is a picture of something what this would look like when you are done.

![](/files/-L9GM4yG8rmnvJkLc3GV)